Sixteen channels on one USB-C cable, for a laptop or a Raspberry Pi. The board, the FPGA design, the firmware and the software are all published.
Every figure says how it was measured. A figure that has not been measured on a board yet is marked by design.
Each kit lists what is in the box and what is not. Each board passes its test before it ships.
Boards marked open hardware come with their design files, firmware and software, so you can read them and change them.
The field guide tells you what is wrong with a board. The kit is what you reach for next.
Each kit is one board with what it needs to work on your bench: a datasheet with measured figures, a quick start guide, and software you can script.

A 16-channel logic analyzer on USB 3, for a computer or a Raspberry Pi.

Three trimmers set the rate, the flash length and the brightness, or a logic pin fires each flash.
A programmable supply that also profiles the current your board draws.
A calibrated USB load: sixteen switched resistor loads with a reference meter.
The KiCad project and the files the boards were made from, the FPGA design, the firmware's source and the host software are in one repository.
Read before you power a board from a laptop.
Note 13 · PowerSix parts that store charge, each running the same load.
Note 47 · HistoryThe connector every kit here plugs into.